I have a 95 or 96 jetsetter. The original heater failed and I replaced it with a new Watkins no fault heater. Everything seemed to work just fine, it heated up and I used it once. I went away over the holiday and had left the door off the pump end. Anyway, I went out to use it and nothing is working. The light on the control panel is not lit and none of the pumps and ozone generator work. I checked the breaker inside and the GFCI plug. The light is lit on the GFCI. I triped and reset it. I also powered down the unit for 5 minutes in case it was the new heater limit. Nothing happened upon power up. I am wondering if there are any resets that I do not know about. Please help.
Curtis

No, there aren't any resets. Did the LED light fall out of its socket? Serial # would help. Sounds like you need to call a tech or it's time to test voltage.