We're Open! Tuesday Evening Sales & Tech Help Available Now! 8:27 Pacific, 7:27 AST, 5:27 PM HST, 1-813-235-4574
Unsure about your purchase? We're available to answer your questions now. Give us a call to help complete your order.
If you're in the Tampa area, come see us at our store. We're located at 14413 North Nebraska Ave! We have the spa parts, pumps and spa packs you need over the counter! Checks, Cash and Credit Cards Accepted! We Export World Wide! |
|
| The information contained in this forum is from SpaForums.Com
and IS NOT AUTHORITATIVE advice or official commentary from SpaPartsNet or SpaBabes Incorporated. Use this information at your own risk! |
| Breaker tripped and doesn't reset |
Hi - We have a two year old ProForm Tempest (Costco special " title="Laughing" /> ). We went out to check temp this morning and the tub was off. Checked the outside breaker and it was tripped and won't reset. " title="Shocked" /> The breaker in the main house panel was not tripped.
We had a pretty wicked storm roll through Thursday night, but nothing else in the house was affected and no power outage or brownout. It would seem a power strike or surge would affect the main panel before the external one, but I'm no pro electrician. Plan is to replace the exterior GFI 50a breaker tomorrow.
Any other suggestions?? Any thought about the tub itself? Think it took a hit, or did the breaker do it's job??
TIA
-PGT |
| Posted by on 2006-09-30 21:46:58. Leesburg, VA (7176) |
|
lightening strikes can burn the pc board up. I would start by checking the pc board and seeing if there are any visable burns. If not test all the fuses for continuity. also you can unplug the pump then try the breaker if it does not work plug the pump back in and do the next pump,ozone,heater. that is a simple way to check what the prob might be. also u can check to see if your getting power to the gfci from the house. hope this helps. |
| Posted by on 2006-10-01 18:45:30. (7185) |
|
it does, thanks. I replaced the 50a outdoor breaker...same symptoms. I did check the voltage with my digital multimeter and it looks like I'm getting voltage from the main panel.
The tub is still under warranty (as long as it didn't take a hit that is). I'm going to call tomorrow for service to see where that gets me. |
| Posted by on 2006-10-01 19:07:15. Leesburg, VA (7186) |
|
update - I pulled the panels off to check each subsystem and there's a persistent leak, right above the main motor. the plywood base is soaked, though is seems everything else is dry and ok. all fuses check out.
I drained the tub for now....need to let things dry out. I'll also cut away the insulating foam to check for the leak - looks like the culprit is a small hose that runs up by the control panel. Not sure what it's for, but it doesn't hit the ozonator. :" title="Question" />
side note - Icon Fitness / ProForm is shirking any responsibility to cover under warranty, despite a different rep telling me that morning it was covered. " title="Rolling Eyes" /> |
| Posted by on 2006-10-03 09:38:45. Leesburg, VA (7220) |
|
Easy solution!! Drained the tub, loading it up and taking it back to Costco for a full refund.
Now...what to buy to replace it? Guess I should start reading up....$4700 to spend (and probably will be on a Costco cash card). |
| Posted by on 2006-10-04 08:12:18. Leesburg, VA (7230) |
|
| | | The information contained in this forum is from SpaForums.Com
and IS NOT AUTHORITATIVE advice or official commentary from SpaPartsNet or SpaBabes Incorporated. Use this information at your own risk! |
Note: Prices and Specifications subject to change without notice
|
|

|
|
|
|
Related @ SpaForums | CalSpa Model 6300 control issue... Update... 11/30/08
I took off the sides to reach the controls and it became all too (more)...
| Air Valve Replacement Beachcomber Tub Hi, I need to replace the air valve on my 2002 beachcomber 530.
While looking inside (more)...
| 3 dots flashing and already replaced the pressure switch Hi,
We have a PDC Spa, actually at one of our rental cabins, and several months ago, (more)...
| 3 dots flashing and alreay replaced the pressure switch Hi,
We have a PDC Spa, actually at one of our rental cabins, and several months ago, (more)...
| Spa pumps turn on and off Yes, when you turn it on it says FLO and the 1 pump that I turned on it's light was (more)...
| Circulation pump wiring issues. I purchased an E5 circulation pump, and the wiring instructions given to me said that (more)...
| Where to buy CalSpa Motor? Techies-
I recently replaced a 6HP pump on a CalSpa, because it had been making a (more)...
| ASI Manhattan Spa Hope you can help,
I've just got the above spa, the heating light has been flashing (more)...
|
|
|
Are you in the Tampa Bay area? Visit Our Store! 14413 N Nebraska in Tampa Florida!
| Copyright © 1997-2008 Spa Babes, Inc. Tampa, FL Sales: 1-866-364-9681 Tech Support: 1-813-235-4574 |
|
|