|
| The information contained in this forum is from SpaForums.Com
and IS NOT AUTHORITATIVE advice or official commentary from SpaPartsNet or SpaBabes Incorporated. Use this information at your own risk! |
| SPA tripping the breaker |
We have an older hot tub and just had it in for servicing. The pump was running fine for two days. Now it keeps tripping the breaker. I can hit the breaker and it immediately shuts off again. Its running on 110 with an appropriate extension cord. After a few hours it will run for about 20 minutes and then shuts off again. Any ideas? Yes the motor does feel hot to the touch but not hot enough to burn your skin.
Nancy |
| Posted by on 2008-07-31 00:20:06. (14072) |
|
Re: SPA tripping the breaker
Pump motors normally feel hot, sometimes VERY hot. The most common cause for your problem is a bad heater. Try unplugging it (if possible) and see what happens (turning the thermostat to off, may, though unlikely, also allow the breaker to remain set). |
| Posted by on 2008-07-31 12:06:31. near San Francisco (14074) |
|
| | | The information contained in this forum is from SpaForums.Com
and IS NOT AUTHORITATIVE advice or official commentary from SpaPartsNet or SpaBabes Incorporated. Use this information at your own risk! |
Note: Prices and Specifications subject to change without notice
|
|

|
|
|
|
Related @ SpaForums | CalSpa Model 6300 control issue... Update... 11/30/08
I took off the sides to reach the controls and it became all too (more)...
| Air Valve Replacement Beachcomber Tub Hi, I need to replace the air valve on my 2002 beachcomber 530.
While looking inside (more)...
| 3 dots flashing and already replaced the pressure switch Hi,
We have a PDC Spa, actually at one of our rental cabins, and several months ago, (more)...
| 3 dots flashing and alreay replaced the pressure switch Hi,
We have a PDC Spa, actually at one of our rental cabins, and several months ago, (more)...
| Spa pumps turn on and off Yes, when you turn it on it says FLO and the 1 pump that I turned on it's light was (more)...
| Circulation pump wiring issues. I purchased an E5 circulation pump, and the wiring instructions given to me said that (more)...
| Where to buy CalSpa Motor? Techies-
I recently replaced a 6HP pump on a CalSpa, because it had been making a (more)...
| ASI Manhattan Spa Hope you can help,
I've just got the above spa, the heating light has been flashing (more)...
|
|
|
| Copyright © 1997-2008 Spa Babes, Inc. Tampa, FL Sales: 1-866-364-9681 Tech Support: 1-813-235-4574 |
|