Spa and Hot Tub Tech Support and Parts Sales Help is often available evenings & weekends if you can't get through in the daytime! Concerned about the economy? Fix your spa now, most people don't need to buy a new tub! (Save Money $$$) If you're in Tampa, stop by our store at 14413 North Nebraska Ave! We have the spa parts, pumps and spa packs you need over the counter! Monday thru Friday 9-5, Saturday 9-3 We Export World Wide! Canada, Mexico, Central/South America, Europe!
The information contained in this forum is from SpaForums.Com
and IS NOT AUTHORITATIVE advice or official commentary from SpaPartsNet or SpaBabes Incorporated. Use this information at your own risk!
flo-master xp2 high speed not working
i am having problems with my motor not running on high speed the low speed works fine but when i switch it to high it makes a loud hum and vibration and pumps slowly everything else works fine
Posted by on 2006-10-13 07:03:03. (7321)
Could be wired incorrectly (L1 and Low wires reversed on the pump), inadequate voltage, or you could have a bad high speed capacitor in the motor, or even bad bearings.
Posted by on 2006-10-15 15:02:59. Albert Lea, MN (7355)
It also could be a control issue and the low speed relay is stuck closed (or miswired) so when you go to high speed it still is trying to run low.
High and low at the same time make a loud hum noise and will heat the motor quite fast. If this is the problem the motor will hum for a few seconds and then the thermal breaker in the motor will shut it down.
The information contained in this forum is from SpaForums.Com
and IS NOT AUTHORITATIVE advice or official commentary from SpaPartsNet or SpaBabes Incorporated. Use this information at your own risk!
Note: Prices and Specifications subject to change without notice
No representations or warranties are made as to the accuracy or completeness of the information contained in this website. Check with a competent professional in your area for assistance.
