1. Sundance 1998 Cameo
2. decicated 220 amp, running on dedicted 50 amp breaker
3. Control is a Sentry 850
4. Topside control is a push button Sentry Zcommand center
5. 2 Pumps
6. Thermostat is a pish button on top side control
7. Heater type is a plastic housing, water goes through bottom, to the top of heater then flows out to the right of the tub
8. There is an ozonator

I bought this used a few weeks back. It ran ok for about 30 hours or so, then I got the error code.

It will run ok for a short time and the heater says it is one while the jets 1 pump is running (2nd pump should not run while heating). After 15 minutes or so, the jet pump 1 shuts off due to a timer. At that point the air kicks on, but only for about 5 seconds then trips the GFCI. When I reset, the watchdog is on for at least 10 hours before it resets.

My questions:
1. Can I extend the period in which the circ pump stays on before auto shut off?
2. Can I be sure this is the air pump? Is there any other tests I can do? I guess I have not really tested so far, it is more something that I noticed.

3. Is there a quicker way to reset the watchdog to run the tests other than waiting x amount of time for it to reset itself?

Thanks, Bob

Sundance Cameo 1997

If I do need to replace the blower, do I need to get the eact same aprt number or are there alternatives I can use?

Bob Johnson