Been reading these forums all day to try and find out what happened to my tub!

Basically I went out to check the tub yesterday as I had not heard the jets running in a few days. Opened the lid and found the TSC not on and the water was cold.

I checked everything I could, I have power coming into the board with 240v and 120v on the correct lines. All fuses checked out when put on a meter to verify they are good. I also noticed a little red LED lit up on the board to the left of the what must be the Microprocessor.

At this point I am pretty sure I need to order a new Spa Pack.

My current parts on the spa are:
TSC: TSC-19-AD-AP2 ( I assume the AP2 is just the designation for Apollo Spas)
Spa Pack is: SSPA-1-P122-B2-O2-LS-HP-AMP- AP2 (Again, assume AP2 must be for Apollo Spas)

Does anyone have any idea what else I can check?

If this board has gone dead then what replacement do I need to use? I can not seem to find the correct replacement item for this.

Any help would be greatly appreciated.

Thanks,
Chris