|
| The information contained in this forum is from SpaForums.Com
and IS NOT AUTHORITATIVE advice or official commentary from SpaPartsNet or SpaBabes Incorporated. Use this information at your own risk! |
| Relay gone or? |
I have a 2001 Sundance Spa with a Balboa controller. 240V M7 marked on the curcuit board. External GFI. Recently draind and refilled the tub. Ran fine for a day then tripped the GFI. When I reset it one of the relays would give a loud click then trip the GFI again. Unplugged everything from the controller, but still have a clicking relay and GFI failure. Any thoughts-bad relay? board? Thanks |
| Posted by on 2008-09-30 06:45:46. (14672) |
|
Re: Relay gone or?
Most likely the clicking sound is the heater relay sending voltage to the heater, and the heater is bad, so the gfci trips. I would check the heater. |
| Posted by on 2008-09-30 23:07:54. Eastern CT (14675) |
|
| | | The information contained in this forum is from SpaForums.Com
and IS NOT AUTHORITATIVE advice or official commentary from SpaPartsNet or SpaBabes Incorporated. Use this information at your own risk! |
Note: Prices and Specifications subject to change without notice
|
|
|
|
|
|
Related @ SpaForums | CalSpa Model 6300 control issue...
Update... 11/30/08
I took off the sides to reach the controls and it became all too (more)...
| balboa vs501z error code HH
The model is a VS501Z; date on inside wiring diagram is 06/12/07, Part # 54356HC1
Hooked (more)...
| Air Valve Replacement Beachcomber Tub
Hi, I need to replace the air valve on my 2002 beachcomber 530.
While looking inside (more)...
| 3 dots flashing and already replaced the pressure switch
Hi,
We have a PDC Spa, actually at one of our rental cabins, and several months ago, (more)...
| 3 dots flashing and alreay replaced the pressure switch
Hi,
We have a PDC Spa, actually at one of our rental cabins, and several months ago, (more)...
| Gatsby circulation pump will not stay running
Hi, new to hot tubs but after reading many posts I think I may need to replace the (more)...
| Spa pumps turn on and off
Yes, when you turn it on it says FLO and the 1 pump that I turned on it's light was (more)...
| Circulation pump wiring issues.
I purchased an E5 circulation pump, and the wiring instructions given to me said that (more)...
|
|
|
| Copyright © 1997-2008 Spa Babes, Inc. Tampa, FL Sales: 1-866-364-9681 Tech Support: 1-813-235-4574 |
|
