|
| The information contained in this forum is from SpaForums.Com
and IS NOT AUTHORITATIVE advice or official commentary from SpaPartsNet or SpaBabes Incorporated. Use this information at your own risk! |
| NO Power to 2002 Baja Tub |
GFI kicks out without powering anything. I have unplugged (disconnected ) all pumps and blowers but I cannot get power to my unit. I am thinking that I should remove power to the heater but I thought that I might ask for suggestions. I am guessing that the heater may be the issue but looking for some guidance. |
| Posted by on 2008-10-12 14:58:43. (14790) |
|
Re: NO Power to 2002 Baja Tub
The heater is the most common cause of a tripping GFCI. |
| Posted by on 2008-10-12 16:29:39. near San Francisco (14792) |
|
Re: NO Power to 2002 Baja Tub
You are entirely correct as I finally unplugged the heater connection and I have power to the tub. Anything that I can do to revieve a heater other than replace? |
| Posted by on 2008-10-12 17:00:22. (14793) |
|
Re: NO Power to 2002 Baja Tub
I'm sure there's got to be some way to repair bad heater elements...I'm also sure the cost to do so would be 10 to 100 times the cost of a new element  " title="Mr. Green" /> |
| Posted by on 2008-10-12 18:49:21. near San Francisco (14794) |
|
| | | The information contained in this forum is from SpaForums.Com
and IS NOT AUTHORITATIVE advice or official commentary from SpaPartsNet or SpaBabes Incorporated. Use this information at your own risk! |
Note: Prices and Specifications subject to change without notice
|
|
|
|
|
|
Related @ SpaForums | CalSpa Model 6300 control issue...
Update... 11/30/08
I took off the sides to reach the controls and it became all too (more)...
| Air Valve Replacement Beachcomber Tub
Hi, I need to replace the air valve on my 2002 beachcomber 530.
While looking inside (more)...
| 3 dots flashing and already replaced the pressure switch
Hi,
We have a PDC Spa, actually at one of our rental cabins, and several months ago, (more)...
| 3 dots flashing and alreay replaced the pressure switch
Hi,
We have a PDC Spa, actually at one of our rental cabins, and several months ago, (more)...
| Spa pumps turn on and off
Yes, when you turn it on it says FLO and the 1 pump that I turned on it's light was (more)...
| Circulation pump wiring issues.
I purchased an E5 circulation pump, and the wiring instructions given to me said that (more)...
| Where to buy CalSpa Motor?
Techies-
I recently replaced a 6HP pump on a CalSpa, because it had been making a (more)...
| ASI Manhattan Spa
Hope you can help,
I've just got the above spa, the heating light has been flashing (more)...
|
|
|
| Copyright © 1997-2008 Spa Babes, Inc. Tampa, FL Sales: 1-866-364-9681 Tech Support: 1-813-235-4574 |
|
