Concerned about the economy? Fix your spa now, most people don't need to buy a new tub! (Save Money $$$) If you're near Tampa, stop by our store at 17420 N US Hwy 41; in Lutz! We have the spa parts, pumps and spa packs you need over the counter! Monday thru Friday 9-5 We Export World Wide! Canada, Mexico, Central/South America, Europe!
The information contained in this forum is from SpaForums.Com
and IS NOT AUTHORITATIVE advice or official commentary from SpaPartsNet or SpaBabes Incorporated. Use this information at your own risk!
NU-Wave Spa Control Blower Problems
I have a NU-Wave (NU-2000) A-24 Control and am having problems with the power to the blower motor. The system is set up for 220v when I hooked the power up all I get is a motor hum. I have checked all my incoming power and have both legs to the control panel. But, seem to only have 120v out to the motor plug.I have been looking for a wiring diagram to make sure I have it wired right. The Control panel and motor set up was new never used 4 years ago. And can be set up for 110 or 220. The blower motor is a 220v motor. Are there internal wiring changes I need to do to supply 220 to the blower? Or has the wrong plug been put on the motor? There are 3 plugs on the right side of the spa control unit: A black 5 hole single slot female connector (not sure what this is for) A blue 2 hole single slot (heater ?) A red 3 hole single slot (blower motor) is plugged into this one.
Any help or link to wiring prints would be greatly appreciated. Thanks
The information contained in this forum is from SpaForums.Com
and IS NOT AUTHORITATIVE advice or official commentary from SpaPartsNet or SpaBabes Incorporated. Use this information at your own risk!
Note: Prices and Specifications subject to change without notice
No representations or warranties are made as to the accuracy or completeness of the information contained in this website. Check with a competent professional in your area for assistance.
