I have working what I believe to be Jacuzzi brand hot tub. We water tested it and it held water with the pump off. Cranked up the 3/4 hp pump and have a leak pump only runs for a minute and trips the breaker. I have a good 1hp waterway pump I'm going to plumb in and retest. Question # 1 how do you check remove the jacuzzi brand jet with the four slots in it. Is it a special tool? Can it be done from just the top side or must we dig out all of foam behind the jet? This tub was manufactured with the shell and skirt one single piece of fiberglass so we would have to turn the tub over. The foam must be a structural part of the tub as the shell material is pretty thin.

thanks
jen

Well instead of swaping pumps and replumbing Hubby tried to swap the wet ends I think that is what they are called. Two through bolts broke easy does it. will keep you posted
fingers crossed
jen