I had a rodent problem with my Sovereign - the little creatures evacuated a large chunk of my insulation to make their house! They're gone now and the mess is cleared up, but I lost most of the water. I thought they had chewed through a hose, but when I refilled and ran the pumps there was no leak. The water seems to be running (dripping) out of a small (1/4 inch) clear plastic pipe that has no end and no place to attach it (the other end of the pipe disappeards into the insulation on the right hand side - as you face the panel). If I tape the pipe higher than the water level, everything is fine, but if I let it spring back to below the water level, it's all gone in a couple of days. So, can anyone tell me what this pipe is and what to do with it? Thanks in advance, Terry

Sounds like an air intake line for one of the jets. If you look up high in the motor compartment there are check valves clipped up into the top of the compartment. This one probably broke off...you may see one up there without a line attached...reattach it or replace the check valve if it broke off.