1. Sundance, Calypso, and 1992
2. 220V, 40a breaker at main, 20' to 60a breaker @ GFCI, 15' to spa, THHN 3-8ga, 1-10 ga green/gnd-
3. Sentry Spa Control System
4. Topside control; Push button pad
5. 1 Main pump
6. Thermostat: knob on topside control
7. Heater Type - i don't know...NOT gas
Problem: Spa not run in about 12 months, moved across town. Old address arrangement 220v 50A breaker at main, about 50' 8 ga + 10 ga ground to 50a GFCI, to spa. See above for new locations power & wiring.
Last night: Disconnected blower & blower fuse (broke-oops) which was tripping GFCI. Pushed JET button 1x, indicator light turns on, but nothing from pump &don't hear click in control box. push jet button 2d time, hear click in control box, but still no pump action or sounds. push 3rd time, hear click again, and jet light turns off. I pushed jet button again, light comes on, and after about 10 minutes pump spontaneously started. Ran about 5 minutes, quit, started and ran again, quit. went on for about 1/2 hour, now quit and wont start at all. Today, pushed jet button and left light on, never spontaneously started. I'm at my wits end! Please help
ps. since i am disabling blower for now, if it is the switch, can i swap the blower & pump switches on control board...are they "plug n play" or soldered in back? they are identical.