|
The information contained in this forum is from SpaForums.Com
and IS NOT AUTHORITATIVE advice or official commentary from SpaPartsNet or SpaBabes Incorporated. Use this information at your own risk!
This topic has attachments which you can't view here. To see this topic in its entirety,
Click Here |
| Rec'd OH code, replaced temp sensor, refilled, now Sn...HELP |
Last summer, the cover was broken and so I ran the tub at around 99degrees with only a tarp to cover the tub. After a few weeks, the tub would stop heating and flash "OH". I'd shut off the tub at the knife-switch, flip it back on, and it would heat up just fine for a few days. After a week or so of this, I researched online, I replaced the temp sensor (part #BAL 30352 generic 96 temp sensorw/ 3 8 bulb for value & LE systems). After getting that replaced, I fill the tub and go to flip the knife-switch out at the deck, and the display shows a "0" for a few seconds, and then shows a "Sn" code.
Should I have replaced the hi-temp sensor instead/too? Please help!!! |
| Posted by on 2009-05-04 21:53:37. (16828) |
|
| This topic has attachments which you can't view here. To see this topic in its entirety,
Click Here | | | The information contained in this forum is from SpaForums.Com
and IS NOT AUTHORITATIVE advice or official commentary from SpaPartsNet or SpaBabes Incorporated. Use this information at your own risk!
This topic has attachments which you can't view here. To see this topic in its entirety,
Click Here |
Note: Prices and Specifications subject to change without notice
|
|
|
| Copyright © 1997-2009 Spa Babes, Inc. Tampa, FL Sales: 1-866-364-9681 Tech Support: 1-813-235-4574 |
|
