Just refilled the tub Sunday. It started up just fine, but this morning I noticed the pump was running on low. I thought it was just on a heat cycle so I didn't look under the cover.
Came home from work and it was still running on low..but I looked and the display is blank. Buttons seem to work for the pumps and the light, but no temp display at all..the water is at the set temp too, I checked it...
Any ideas?? Bad control panel???

fixed it..so never mind...
little field mouse chewed through the cable to the topside controls. luckily it was a normal cat 5 cable and I had a few in the closet..
set a couple traps in there to finish the little bugger off. she was watching me from in deep while I cursed her for building a nest under the spa pack...pulled the nest and all her acorns out with a shop vac...should sucked her into it too..