Hi all,

I recently obtained a Cal Spa Eliminator Series and have wired everything up. All the pumps and jets work properly however, I can't get it to heat. The heat pump light comes on for a second then shuts off. I let it run all night to see if the temp would raise at all but no dice. Everything seems to be in working order but the it just won't heat....any help?

It is a 220v, 50 amp. Also, there's was a 3/8 hole that had water running out that could be where the pressure switch was located. It's on the line that runs out of the pump on the left side and it has another hole with a sensor that appears to ground to the control panel on the inside. I didn't know last night what was supposed to be there so I have it capped for now. The pressure switch appears to have the same threads as the hole I capped but I was thinking the switch should be inside the control panel. Thought that might be helpful in resolving the issue.