Complete Pump, Aqua-Flo, XP2e,4.0HP ,230v, 56fr, 2"x 2, 1 or 2 Speed 15A

This Jet Pump is found from the factory in many hot tubs and will be an easy installation for people who are handy.  

This pump is a 4-5HP 56 frame 230V Side Discharge wet end with a 2" suction side and 2" pressure side which measures about 3" edge to edge.

On the label on this pump show the amperages are 15.0 on High Speed and 4.8 on low making it a between a 4 and 5 horse power using our HP Chart. Although this pump is a high horse power pump be careful when you order and try to make more power on your hot tub if you have weak or undersized wiring a high amperage pump like this can cause weak areas of your hot tubs system fail.

Note: You need to be sure of your voltage by checking one of two things. Either the label on the pump which will say either 115V or 230V or you can look to see where the white wire from the pump is located in the pack if you can't see the label. If the white wire is on the red leg or #2 leg the pump is 230V if it is on the Neutral or the White AC leg. Always turn the breaker to the hot tub off before doing any of these checks.   

• Fine tuned impeller that moves water through the system with maximum performance
• 2" intake and discharge
• 56-frame motor for added strength
• Thermally protected to extend life expectancy of motor
• Continuous duty horsepower of 1.5hp, 2.0hp, 3.0hp, 4.0hp, and 5.0hp. Single or dual speed (SEE THE AVAILABLE STYLES TAB)