Cords, Plugs, and Receptacles

Splitter Cable, Pp-1 Amp Male To 2 Female, 6''

AMP cable splitter for use with gecko or Balboa spa packs. This 14/3 splitter is commonly used for the circulation pump and the ozonator to share one receptacle on the main circuit board. It has a 6" length with one male AMP plug and 2 female AMP...

Balboa VS, GL, GS Plug and Click Female Heater Power Wire Adapter, Quick Disconnect

Female quick disconnect for Balboa plug and click heaters. This 6" adapter connects to the heater terminals on your circuit board and then plugs into the male 25263 adapter from your heater on the new Balboa VS, GS and EL circuit boards. Also makes a...

Balboa BP Plug and Click Male Heater Power Wire Adapter, Quick Disconnect

Male quick disconnect for Balboa plug and click heaters. This 16" adapter will connect to your heater element terminals and will either plug directly into the circuit board on BP systems or into the 25696 female adapter on the new Balboa VS, GS and EL...

HydroQuip Versi-Heater Power Cable Harness, 3 Prong, 30"

Power cable harness for certain HydroQuip Versi-Heaters like the 26-87B-S00-1FP3 model. This 3 wire 30" power cord comes with a rubber molded prong with 2 round and one flat pin, commonly known as a Mini J&J (MJJ) plug. To install - Connect the black...

Power Cord, Ozonator, Yellow, HydroQuip and MJJ, 18/3

Rubber molded MJJ style power cord for the ozonator circuit on HydroQuip CS systems and some Gecko S-Class systems. Previous versions of this cord where clear and had a light that illuminated, but that is no longer available. Please see the third picture...

Pump Power Cord, Mini J&J Red, SMD/VDS, 48", Red, Pump 1, 2-Speed

Mini J&J (MJJ) style power cord for a 2 speed primary pump #1. The 48" versions are in limited supply and once those are gone we will send this in the 96" length. This cord makes a great replacement for any brand spa that uses this rubber molded...

Power Cord, AMP, 2 Speed Pump, 14/4, 4 Wire, 96"

Amp Cord, Pump 1, 2-Speed, 4-Pin Amp, 14/4, 96"Long The Wire colors are as follow on most systems: Red=High Speed Black=Low Speed White=Neutral or Common Green=Ground There are exceptions to these colors versus speed as there are some systems where...

Pump Power Cord, Single Speed For Power Depot - Now Comes in 8 Foot Length!

Single speed pump cord with in.link connector for the Power Depot, In.Xe, In.Xm, and In.Xm2 spa packs and controls. This 3 wire cord enables a solid water tight connection between your pump and spa pack. Now comes in a 96"length Common part used in...

Pump Cord, 2 Speed For Power Depot, In.Xm and In.Xe, 8 Ft, 230 V

High current 2 speed pump cord made by Gecko for the Power Depot, In.Xm and In.Xe spa packs and control systems. This 4 wire 8 Ft cord wires to your pump motor to pick up both low and high speed and provides a water tight connection at your spa pack...

Light Cord Extended, 12 Ft For The Power Depot, In.Xm, and In.Xe Control Systems

Extended light cord for use with many 2006-2008 Gulf Coast Spas, Garden Leisure Spas, Pilates H2O Spas, La-Z-Boy Spas and more. This cord is also compatible with other hot tub and spas brands that use the Gecko In.xm and in.xe control systems. Accepts...

Adapter Cord 3 Pin AMP to In.Link 120 Volt, Silent Aire Blowers

Adapter cord used with the Silent Aire Blower to convert the included 3 prong AMP plug to the In.Link style plug found on the In.Xm, In.Xe and the Power Depot spa packs. This cord has a 96" length and is a low amperage cord for use with 110/115 volt...

Adapter Cord 3 Pin AMP to Molded MJJ Style 6" - Silent Aire

Adapter cord used with the Silent Aire Blower to convert the included 3 prong AMP plug to the rubber molded Mini J&J (MJJ) style plug. This cord has a 96" length and is used with 115 or 230 Volt air blowers Male End Plug Style Mini J&J (MJJ) -...

Balboa P2+4 Pump Y Splitter Cable, AMP -25801

Balboa "Y" splitter cable to enable a 4th pump on the BP7 spa packs and retro-fits. The cable plugs into the pump 2 extension relay and provides a female amp plug for both pump 2 and pump 4. Both pumps will run off of the same pump 2 button and will be...

Amp Cord, Pump, 2-Speed, 4-Pin Amp, 14/4, 72"Long

This part is a Amp Cord, Pump 1, 2-Speed, 4-Pin Amp, 14/4, 72"Long, Plug Attached, w/Terminated Ends. The Wire colors are as follow on most systems: Red=High Speed Black=Low Speed White=Neutral or Common Green=Ground There are exceptions to these colors...

Jacuzzi or Sundance, 6660-197, Control Pack or Board Terminal Block 3 Position Repair

This part is a 3 Terminal Power Block found on some Jacuzzi or Sundance Control pack and board set ups.. This part is found in some Jacuzzi Premium J-220, J-210, J-315, J-310, 2004 J-325, and 2008+ J-325 models and some Sundance 800 or 850 systems....

Ground Bus Bar, 5 Position, 14-6 AWG Balboa or Gecko

This part is a Ground Bar found on many Balboa Brand Spa Hot Tub packs as well as some Gecko SSpa and Mspa packs. a

Jacuzzi or Sundance Control Pack Board Terminal Block, 6660-192, 50A, 2 Position Repair

  This part is a 3 Terminal Power Block found on some Jacuzzi or Sundance Control pack and board set ups..   Jacuzzi® Spa Terminal Block, Two Position Strip (TB1, All Models Except The J-380/J-385, J310/J-315 And J-230). Also...

Control Pack or Board Terminal Block 3 Position Repair

You are purchasing a 3 Terminal Power Block found on many Control pack and board set ups..

Female, AMP, Connector, 5 Pin, Board, Control Box Side

This part is a 5 pin female side Amp connector 20 Amp . This part is normally found on the control pack side mounted for the male amp cord that would come from a pump or blower or other accessory. Note: You will need a pin tool to replace this part to...

Plug, Housing, Female, AMP, 2 Pin, Control Box Board Side, Light Connector

This part is the Control Box Board Side Female AMP Connector that houses (2) Female Pins.. The Pins are not included.. This connector is used often on light cables.. Terminal Type AMP Terminal Style AMP Plug Housing Female Number of...

How To Video GFCI Breaker Tripping New Wire Up Hot Tub Diagnose The Spa Guy

This video is The Spa Guy teaching you how to Diagnose a New Wire Up Situation where you just wired your hot tub up and it is tripping the breaker and it is either a new tub or it is used and ran fine at the last location...... Save

Hot Tub GFCI Breaker Information How To DIY The Spa Guy

The Spa Guy is talking here about the ins and outs of wiring a GFCI Breaker. Please consult your local codes for actual wiring rules...  #sparepair #hottubrepair  #hottubhowto Save

3 Wire not 4 Wire Hot Tub Wire Up Jacuzzi Sundance Vita How To The Spa Guy

The Spa Guy is talking here about the ins and outs of wiring a 3 Wire Jacuzzi Premium, Sundance, Vita Spa, Keys Backyard or other brand instead of the normal 4 wire GFCI Breaker system...

Voltage in The Water on a Hot Tub How To Video from The Spa Guy

In this video The Spa Guy shows actual voltage in the water on a hot tub and what caused it. a Missing ground on the GFCI box when the hot tub was wired!! Once again The Spa Guy Saves the Day!! Your Hot Tub Super Hero  #sparepair #hottubrepair...

How To Video Hot Tub GFCI Breakers The Basics The Spa Guy Breaker

This video is about The Spa Guy teaching you the basics of GFCI Hot Tub Wiring and the ins and outs of wiring a Hot Tub...  #sparepair #hottubrepair  #hottubhowto Save

Balboa Board Terminal Block 3 Position Repair Value SUV Video How To

We do have these in stock now!! This part is an Old Style 3 Terminal Power Block found on many Balboa Brand Spa Hot Tub Boards. This terminal Block can get burned on one leg if you can solder you can replace this part and not buy a board if this is the...

Control Box Side Pin Housing, Female, AMP, 3 Pin, Plug, Connector

This part is the Control Box Side Female AMP Connector that houses (3) Female Pins.. The Pins are not included..   Terminal Type AMP Terminal Style AMP Cap Housing Female Number of Connections 3 Terminal Amperage 20A The other parts...

Cord Kit, Circ Pump, Retrofit, For PS-6502/6503, Blue

Cord, H-Q, P1, 2Spd, Molded/Lit, 48", 115v/230v, 15A, Red

Mini Size Molded/Lit CordRed - Pump 1/2 Speed

Heater Wire, Gecko M-Class, 3"

Gecko has discontinued this heater strap and we now send the new version here: Jumper Wire, Heater Element, 10 gauge x 4", Board to Heater Gecko 3" heater strap used on some M-Class spa packs to connect the heater terminals to the circuit board...

Heater Wire, Gecko S-Class, 1-1/2"

Adapter Cord, Wye, 1 to 2 Appliance, Amp

Pin, Female, AMP, 14-20 AWG, Bag of 25, Plug, Connector

This part is an Amp Style Female Pin crimp connector that fits wire that is 14-20 Gage and is usually found on the pack or board side plug connector that is mounted on the board housing.. This listing is 25 Pins..   Terminal Type AMP Terminal...

Plug, Housing, Male, AMP, 3 Pin, Cord Side

This part is the Cord Side Male AMP Connector that houses (3) Male Pins.. The Pins are not included..   Terminal Type AMP Terminal Style AMP Plug Housing Male Number of Connections 3 Terminal Amperage 20A The other parts related to this...

Pin, Male, AMP, 14-20 AWG, Bag of 25, Plug, Connector

This part is an Amp Style Male Pin crimp connector that fits wire that is 14-20 Gage and is usually found on the pump or other accessory side plug connector that is mounted on the cable.. This listing is 25 Pins..   Terminal Type AMP Terminal...

Plug, Housing, Male, AMP, 2 Pin, Cord Side, Light Connector

This part is the Cord Side Male AMP Connector that houses (2) Male Pins.. The Pins are not included.. This connector is used often on light cables.. Terminal Type AMP Terminal Style AMP Plug Housing Male Number of Connections 2 Terminal...